A polymer emulsion modified, cement and acrylic-based, two-component fully elastic
waterproofing product.
General Characteristics
• It is easy to prepare and apply.
• Its full flexibility bridges shrinkage cracks.
• The working time is long.
• It can be used in areas affected by vibration.
| Appearance | Gri Toz, Beyaz Sıvı |
|---|---|
| Number of Coats | 2 – 3 |
| Application Thickness | 2 - 4 mm |
| Waiting Time | 5 – 6 saat |
| Container Life | 3 saat |
| Consumption | 1,3 – 1,5 kg/m2 |
| Adhesion Strength | ≥ 1,50 N/mm2 |
|---|---|
| Tensile Strength | ≥ 3,50 N/mm2 |
| Negative Water Pressure Resistance | 4 bar |
| Positive Water Pressure Resistance | 10 bar |
| Capillary Water Absorption | (kg.m-2.dk-0,5) ≤ 0,10 |
| Fire Reaction Class | Bs1d0 |
It is used as a waterproofing material in all buildings, including wet areas such as balconies, kitchens, toilets, and bathrooms, for ceramic underlay waterproofing, foundation waterproofing, water reservoirs, swimming pools, and terraces (with protection on top).
Packaging A: 20 kg Kraft, B: 10 kg Canister, Color: Gray It should be stored in a clean, dry, and moisture-free environment between +5°C and +35°C, away from direct sunlight. It must be protected from water, frost, and severe weather conditions. It should be stacked up to a maximum of 10 layers. Provided the specified storage conditions are followed, the storage life is a maximum of 12 months from the production date.
During application and mixing, contact with skin and eyes should be avoided. In case of contact, wash thoroughly with plenty of water. If the material comes into contact with eyes, immediately rinse with plenty of water and seek medical attention. Protective gloves, clothing, mask, and goggles should be worn during use.
The B component of FLEX 325 should be slowly mixed with the A component using a low-speed mixer for about 2-3 minutes until a homogeneous consistency is achieved. After the mixture rests for 2 minutes, it should be mixed again for 30 seconds to prepare it for application. FLEX 325 should be applied to the entire surface in at least two coats using a brush or spraying method. If applied with a brush, each coat should be applied in a direction perpendicular to the previous one. Reinforcement mesh should be applied immediately after the first coat. There should be a waiting period of at least 5 hours between coats. The surface should be clean, damp, smooth, and solid. Significant defects and holes in the surface should be repaired with NANOREP FT70/30 series repair mortars at least 24 hours before applying FLEX 325. To ensure the continuity of the waterproofing, vertical and horizontal corners should be chamfered. Surfaces like raw concrete and cementbased plaster should be wetted with clean water and allowed to remain moist until the water layer disappears. For porous surfaces, FLEX 325 should be used as a primer to balance the surface’s water absorption.