Natural hydraulic lime-based injection mortar
It is an injection mortar developed for historical buildings, containing pozzolanic lime
and micronized carbonates.
General Characteristics
It has high adhesion strength, strong binding properties, and is easy
and comfortable to apply. When mixed with water, it undergoes a
hydraulic reaction, gaining hardening and setting properties. It does
not contain any additional additives and is free of cement. It has high
water vapor permeability and is breathable. It does not contain asbestos
and is environmentally friendly. It is compatible with the structure and
the chemicals to be applied later. Suitable for sulfate environments. Its
flexible, super-fluid structure makes it suitable for filling voids. Controlled
expansion prevents later shrinkage.
| Appearance | Crushed White - Powder |
|---|---|
| Compressive Strength - 28 Days | 4,52 N/mm² |
| Application Temperature | +5°C / +35°C |
| Water Ratio | 6 - 8 hours |
| Reaction to Fire | Non-flammable |
It is used in historical monument repairs similar to lime mortar, historical monument restoration, stone and brick wall masonry, plaster repairs, and in the repair and reinforcement of cracks.
Sarfiyat: Çatlak tipine göre değişkenlik gösterir. Ambalaj : 20 Kg Kraft Torba Direkt güneş ışığı almayan dona ve rutubete karşı korunmalıdır. Kapalı depolarda ve açılmamış, orijinal ambalajında 12 ay .
Consumption: Varies depending on the type of crack. Packaging: 20 kg Kraft Bag It should be protected from direct sunlight, frost, and humidity. It can be stored for 12 months in closed warehouses in its unopened original packaging.
MIXING METHOD: Add NANO DHK - INJEC to the appropriate amount of water while the mixer is running at low speed. Slowly increase the mixer speed to approximately 500 RPM. Mix until the mortar becomes homogeneous and free of lumps, then let it rest for 2-3 minutes. It should be mixed again before application. APPLICATION METHOD: The crack, gap, surface, or other areas to be applied must be clean, dust-free, and sound. Loose and readyto-fall areas should be cleaned. The cleaning process should be done using historic building cleaning plaster. Before application, the material should be mixed again until it reaches a homogeneous consistency, then application should begin. For the crack, holes should be drilled at intervals at a 45° angle, reaching the end of the crack’s depth, depending on the crack’s width and depth. These holes should be cleaned of all dust and debris by holding air inside. Plastic packers should be nailed and fixed into the drilled holes, then the injection mortar should be injected. For cracks between 1-5mm wide, holes should be drilled every 20-25 cm. For cracks larger than 5mm, holes can be drilled every 60-100 cm. After application, all equipment should be cleaned, and the product should be washed with water before it hardens.