Epoxy-based, three-component, high-strength, flowable grout mortar.
Epoxy-based, three-component grout mortar with high mechanical strength, non-shrinking,
and self-leveling properties. It complies with TS EN 1504-
3:2008 standard and is classified as R4.
General Characteristics
• Does not contain solvents.
• Allows easy application without primer.
• Due to its chemical structure, it has high tensile, flexural, and
compressive strength.
• Shrinkage is prevented, and it does not shrink.
| Application Thickness | 4 mm 50 mm |
|---|---|
| Workability Time | 40 min. |
| Full Curing Time | 7 days |
| Compressive Strength | (1 day): >40 N/mm² (7 days): >70 N/mm² |
| Flexural Strength | (1 day): >15N/mm² (7 days): >25 N/mm² |
| Flexural Strengthı | (Steel, 28 days): >3.0 N/mm² - (Concrete, 28 days): >2.0 N/mm² |
It is used in the repair of concrete floors in ports. It fills the gap between reinforced concrete columns and steel cladding. It provides excellent results in the repair of wide cracks in reinforced concrete slabs. It is used for repair purposes before epoxy and polyurethane-based floor coating applications. It is used in the repair of reinforced concrete structural system components. It is used in the fixation of machine footings. It is used in the fixation of flagpoles and metal anchors.
15 kg set Component A: 2,000 kg tin can Component B: 1,000 kg tin can Component C: 12,000 kg stitched bag It should be stored in a dry environment between +5°C and +30°C, protected from freezing, and in its original packaging. If proper storage conditions are maintained, it can be stored for up to 18 months from the production date.
During application and mixing, contact with skin and eyes should be avoided. In case of contact, wash thoroughly with plenty of water. If the material comes into contact with the eyes, immediately wash with plenty of water and seek medical attention. Protective gloves, clothing, mask, and goggles should be worn during use.
Surface Preparation: The surface to be applied should be cleaned, and if necessary, roughened. It should be free of foreign materials such as grease, rust, paint, and dust. The concrete to be applied should be at least 28 days old, and the surface should be dry. Steel surfaces should be blasted with sand or cleaned with a brush until the metal is shiny. Rust on reinforcement should be cleaned, and new reinforcement should be added if necessary. Mixing: Component A should be added to Component B and mixed for 1-2 minutes with a low-speed mixer. Then, dry and powdery Component C should be added and mixed for approximately 3-4 minutes until a homogeneous mixture is obtained without creating air bubbles. Application: POX MORTAR - 625 should be poured into mold cavities or onto the surface immediately after mixing. The application thickness should be between 4 and 50 mm.