It is a cement-based, non-structural, coarse-grained repair mortar.
NANOREP FT35 is a single-component, polymer-modified, non-structural thick repair mortar
that forms a thickness of 5-30 mm on concrete surfaces
where it is applied. It has a thixotropic-trowel consistency.
General Characteristics
It provides high adhesion strength to the concrete surfaces where it is
applied. It ensures a smooth surface finish. Thanks to its non-shrink,
non-pulling, and non-shrinking properties, cracks do not form. It does
not crack or sag. It provides good adhesion. It is fiber-reinforced. It
ensures a smooth surface finish.
| Mixture Density | 1850 kg/m3 |
|---|---|
| Water Mixing Ratio | %25 |
| Pot Life | 30 minutes |
| Application Temperature | +5°C / +30°C |
| Service Temperature | -15°C / +80°C |
| Compressive Strength | ≥ 10 N/mm2 |
| (28 days) Tensile Strength | ≥ 0,8 N/mm2 |
• Used for the repair and surface leveling of concrete structures. • Used for the repair and plastering of raw concrete surfaces. • Used for plastering and repairing walls and ceilings. • Used for the repair of concrete under ceramic tiles and surface leveling.
25 kg polyethylene-reinforced kraft bag It should be stored in a dry environment between +5°C and +30°C, protected from frost, and in its original packaging. A maximum of 3 pallets can be stacked; for long-term storage, pallets should not be stacked. If proper storage conditions are maintained, it can be stored for 12 months from the production date.
During application and mixing, contact with skin and eyes should be avoided. In case of contact, wash thoroughly with plenty of water. In case of eye contact, rinse immediately with plenty of water and seek medical assistance. Gloves, protective clothing/mask/goggles should be worn during use.
Surface Preparation: Before applying NANOREP FT-35, the surface must be cleaned of dust, oil, paint, curing agents, and any other substances that prevent penetration. Damaged areas on the surface should be repaired. The surface must be roughened to ensure adhesion. Any water leaking from the structure must be stopped; otherwise, the leaking water will dissolve the applied material before it hardens. The surface temperature to be applied should not be high. The surfaces should be saturated with water before application, and during application, the surface should be free of standing water. Mixing: NANOREP FT-35 is mixed by adding water. The water-to-powder ratio is 25% by weight of the powder (do not use water with a pH value lower than 5.5). First, add 5-6 liters of water into a container, then add the 25 kg of material from the bag to the water and mix continuously for 4-5 minutes. Let it rest for 2-3 minutes, then mix again for 30 seconds before applying. Application: NANOREP FT-35 is applied to a damp concrete surface with a trowel. Wait for the mortar to absorb the water, and then water is sprinkled, and the finishing is done with a steel or wooden trowel.