Water-repellent insulation material for exterior walls”
Acrylic-based, silicone-modified, transparent, water-repellent insulation material. It
can be applied to both interior and exterior walls, providing
protection against UV and external factors.
General Characteristics
It reduces the water absorbency of building materials’ surfaces and,
thanks to its water-repellent properties, is used as a protective material
against dirt and external effects. It does not alter the appearance of
exterior coatings. After washing and rainfall, the surface gains a
renewed appearance.
| Drying Time | 20°C, 65% bağıl nemde |
|---|---|
| Touch Dry | 1 Hourt |
| Fully Cured | 12 Hours |
| Chemical Curing | 24 Hours |
| Density | 1,00 ± 0,03 |
|---|---|
| Thinning | Ready to use, no thinning required. |
| Consumption | 0.15 - 0.20 kg/m² (single coat) |
| Packaging | 1, 2.5, and 15 liter buckets |
It is used in both indoor and outdoor environments to protect surfaces from atmospheric effects, add water resistance, and achieve a vibrant appearance on surfaces such as concrete, drywall, travertine, natural stone, decorative brick, mineral and plaster-based coatings, marble, granite, and historical artifacts. It can be applied to slightly damp or water-based coating materials.
Avoid contact with eyes and skin. In case of eye or skin contact, seek medical attention immediately. If swallowed, seek medical advice or contact a poison control center immediately. Do not attempt to induce vomiting, and do not give anything by mouth. Wash your hands thoroughly after using the product. Wear protective clothing, gloves, and eye and face protection. Do not eat, drink, smoke, or use tobacco while using the product. Remove contaminated clothing and dispose of the product and its packaging in accordance with legal regulations. Keep the container closed when not in use. Store in a place out of reach of children.
The surface should be cleaned of blistered and peeling paints, loose and unstable particles, efflorescence, and dust, and must be solid. Cracks on the surface should be repaired with special repair mortars and putties. The product should be applied without thinning using a spray, roller, or brush until the surface is saturated. On highly absorbent surfaces, the material should be applied in two coats with a 4-hour interval. Care should be taken to prevent the material from running on the surface. During application and for 24 hours afterward, the ambient temperature should be between +5°C and +35°C, and the surface should be protected from rain.